|
|
|
Topics
- General product information
- Temperature control and measurement
- WinVue current version downloads
- Other WinVue support files
- Win-MC
- Information of interest to programmers
- Legacy software information
General product information
White paper: Diode Guard - breakthrough in laser diode protection
Stand-alone operation (without a PC or other computer attached) - "Autostart"
Fault handling and fault codes for all Vue series controllers
Setup and use of the firmware constant power mode for MV and HCV controllers
Temperature control
Applications note: Temperature control and measurement
Important information about TEC selection, temperature servos, selection and calibration of thermistors
Applications note: Using multiple TECs and multiple controllers to regulate a single load
Combining the TEC controller with a laser diode controller (the passthrough feature)
WinVue current version downloads (.zip files)
Some of the entries in the list below are for "demo" versions of the program. These demos contain simulations of most of product's functionality, and allow you to familiarize yourself with the features of each controller. They cannot be used to interface to an actual unit.
Not all products are at the same revision level. Only the latest versions are archived here; for older ones please contact us.
WinVue miscellaneous support
Upgrade for LV-15, LV-30 and TEC USB communications
The latest version fixes a problem with a memory leak (8/3/09) and intermittent comm timeouts (3/2/10). If your version of WinVue for one of these products is dated earlier than this, and you use USB, you need to download this patch.
This file replaces one of the same name in the main program's directory.
msvcr71.dll. On some computers this Microsoft file is needed to run WinVue. If this is the case, download this file and place it in the main WinVue directory.
gdiplus.dll. On some new XT computers this file might be needed to run WinVue.
Dependency Walker: A tool for finding .DLL files that WinVue needs and are missing from your PC.
Win-MC - user interface for MC
Complete CD rom content as .zip file
After unzipping run setup.bat.
Zip file includes the product manual.
Programmer documentation
How to interface to a Vue series controller
Using USB with the LV-15, LV-30 and TEC controllers
Fault handling and fault codes
Uploading firmware in a non-WinVue environment
(Documentation only; contact the factory for the programming kit)
Command sets. These pages contain full documentation for all commands on a product by product basis.